TestEquity UK
Aim-TTi
Aim-TTi

Aim-TTi LD400P DC Electronic Load, 400W / 600W, USB, RS232, LAN, LXI, LD400 Series

Part #28895.1

MFG #LD400P

Aim-TTi LD400P
Aim-TTi
Aim-TTi

Aim-TTi LD400P DC Electronic Load, 400W / 600W, USB, RS232, LAN, LXI, LD400 Series

Part #28895.1

MFG #LD400P

£1,348.00(Excl. VAT)

  • Versatile solution for testing dc power sources
  • Constant current, resistance, conductance, voltage and power modes
  • Wide voltage and current range, 0 to 80V and 0 to 80A
  • 400 watts continuous dissipation at 28°C (360W at 40°C)
  • 600 watts short-term dissipation (up to 60 seconds)
  • Low minimum operating voltage of <1V at 40A
  • High resolution and accuracy for level setting
  • Built-in transient generator with variable slew
  • Current monitor output for waveform viewing
  • Variable drop-out voltage for battery testing
  • High resolution backlit graphic LCD with soft key control
  • Analogue remote control of levels and TTL control of on/off and transient switching
  • Front and rear input terminals (front terminals 30A max.)
  • Full bus control via USB, RS232 and LXI compliant LAN interfaces (LD400P)
  • GPIB option (LD400P only)

DC 360W 80A 80V Electronic Load USB, RS232 LAN/LXI

The LD400 is an inexpensive electronic load which is suitable for testing and characterizing a wide variety of dc power sources. It can be used to investigate the behaviour of many different types of power source such as batteries and solar cells, as well as electronic power supply units. Its wide voltage/current range, multiple operating modes and built-in transient generator give it the versatility to offer test solutions from the design laboratory through to the component test area. The LD400P adds full bus remote control via USB, RS-232 and LAN (Ethernet) interfaces.

The LD400 can operate at voltages below 500mV for currents up to 10 amps. At higher currents the fixed minimum resistance (typically better than 25mW) gradually raises the minimum operating voltage, but it remains below 1 volt up to 40 amps and below 2 volts up to 80 amps. This low operating voltage allows it to be used for many low voltage applications for which other electronic loads are unsuitable.

The LD400 can operate at power levels up to 600 watts for periods of up to 1 minute. Short term loading can be sufficient for many testing applications and significantly extends the usefulness of the LD400.


BrandAim-TTi
Maximum Power400 W
Power Range Selector200-499
Maximum Current80 A
Maximum Voltage80 V
Mounting StyleBench Top
InterfaceUSB,LAN,RS232
SeriesLD400 Series
Operating ModesCC,CP,CR,CG,CV
£1,348.00(Excl. VAT)